Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Guia Do Programa

The commands in this chapter are in one of four functional groups:

Show commands. Display switch settings, statistics, and other information.

Configuration commands. Configure features and options of the switch. For every 
configuration command, there is a show command that displays the configuration setting.

Copy commands. Transfer or save configuration and informational files to and from the 
switch. 

Clear commands. Clear some or all of the settings to factory defaults.

The AutoInstall feature enables the automatic update of the image and configuration of the 
switch. This feature enables touchless or low-touch provisioning to simplify switch 
configuration and imaging. 

AutoInstall includes the following support:

Downloading an image from TFTP server using DHCP option 125. The image update can 
result in a downgrade or upgrade of the firmware on the switch. 

Automatically downloading a configuration file from a TFTP server when the switch is 

booted with no saved configuration file.

Automatically downloading an image from a TFTP server in the following situations:

When the switch is booted with no saved configuration found.

When the switch is booted with a saved configuration that has AutoInstall enabled.

When the switch boots and no configuration file is found, it attempts to obtain an IP address 
from a network DHCP server. The response from the DHCP server includes the IP address of 
the TFTP server where the image and configuration flies are located. 

After acquiring an IP address and the additional relevant information from the DHCP server, 

the switch downloads the image file or configuration file from the TFTP server. A downloaded 
image is automatically installed. A downloaded configuration file is saved to non-volatile 
memory.

AutoInstall from a TFTP server can run on any IP interface, including 

the network port, service port, and in-band routing interfaces (if 
supported). To support AutoInstall, the DHCP client is enabled 
operationally on the service port, if it exists, or the network port, if 
there is no service port.