Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Guia Do Programa

 Begins on second Sunday of Nov at 03:18

 Ends on second Monday of Nov at 03:18

 Offset is 120 minutes

 Summer-time is in effect.

This section describes the commands you to configure the DHCP server settings for the 
switch. DHCP uses UDP as its transport protocol and supports a number of features that 
facilitate in administration address allocations.

This command configures a DHCP address pool name on a DHCP server and enters DHCP 
pool configuration mode. 

This command removes the DHCP address pool. The name should be previously configured 
pool name. 

This command specifies the unique identifier for a DHCP client. Unique-identifier is a valid 
notation in hexadecimal format. In some systems, such as Microsoft® DHCP clients, the 
client identifier is required instead of hardware addresses. The unique-identifier is a 
concatenation of the media type and the MAC address. For example, the Microsoft client 
identifier for Ethernet address c819.2488.f177 is 01c8.1924.88f1.77 where 01 represents the 
Ethernet media type. For more information, refer to the “Address Resolution Protocol 
Parameters” section of RFC 1700, Assigned Numbers for a list of media type codes.

Default

none

Format

ip dhcp pool name

Mode

Global Config

Format

no ip dhcp pool name

Mode

Global Config

Default

none

Format

client-identifier uniqueidentifier

Mode

DHCP Pool Config