Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Guia Do Programa

1/0/7      Designated  Forwarding     3000        128.7

1/0/8      Designated  Forwarding     3000        128.8

0/1/1      Disabled    Disabled       3000        128.1026

0/1/2      Disabled    Disabled       3000        128.1027

0/1/3      Disabled    Disabled       3000        128.1028

0/1/4      Disabled    Disabled       3000        128.1029

0/1/5      Disabled    Disabled       3000        128.1030

0/1/6      Disabled    Disabled       3000        128.1031

This section describes the commands that you can use to configure loop protection. Loop 
protection detects physical and logical loops between Ethernet ports on a device. You must 
enable loop protection globally before you can enable it at the interface level.

This command enables loop protection globally on the switch. As an option, you can 
configure the time in seconds between the transmission of keep-alive packets (that is, the 
transmit interval) and the maximum number of keep-alive packets (that is, the packet count) 
that the switch can receive before an action is taken.

This command disables loop protection globally on the switch. This command also sets the 
transmit interval and packet count to the default value.

This command enables loop protection on an interface.

Default

Disabled

Interval is 5 seconds

Packet count is 1

Format

keepalive [interval] [packet-count]

Mode

Global Config

Format

no keepalive

Mode

Global Config

Default

Disabled

Format

keepalive

Mode

Interface Config