Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Guia Do Programa
Stacking Commands
46
M4200 and M4300 Series ProSAFE Managed Switches
no boot auto-copy-sw allow-downgrade
Use this command to prevent downgrading of the firmware version on the stack member if
the firmware version on the manager is older than the firmware version on the member.
the firmware version on the manager is older than the firmware version on the member.
show auto-copy-sw (for stack firmware synchronization)
Use this command to display the stack firmware synchronization configuration status.
Nonstop Forwarding Commands for Stack Configuration
You can describe a switch in terms of three semi-independent functions: the forwarding
plane, the control plane, and the management plane. The forwarding plane forwards data
packets. The forwarding plane is implemented in hardware. The control plane is the set of
protocols that determines how the forwarding plane must forward packets, which data
packets can be forwarded, and where the data packets must be forwarded to.
plane, the control plane, and the management plane. The forwarding plane forwards data
packets. The forwarding plane is implemented in hardware. The control plane is the set of
protocols that determines how the forwarding plane must forward packets, which data
packets can be forwarded, and where the data packets must be forwarded to.
Application software on the management unit functions as the control plane. The
management plane is also application software that runs on the management unit and that
provides interfaces, allowing you to configure and monitor the device.
provides interfaces, allowing you to configure and monitor the device.
Nonstop forwarding (NSF) allows the forwarding plane of stack units to continue to forward
packets while the control and management planes restart as a result of a power failure,
hardware failure, or software fault on the management unit.
packets while the control and management planes restart as a result of a power failure,
hardware failure, or software fault on the management unit.
You can also manually initiate a nonstop forwarding failover by issuing the initiate
failover
failover
command. If the management unit fails, traffic flows that enter and exit the stack
through physical ports on a unit other than the management unit continue with at most a
subsecond interruption.
subsecond interruption.
To prepare the backup management unit for a failover, applications on the management unit
continuously checkpoint (that is, forward) information to the backup unit. Changes to the
running configuration are automatically copied to the backup unit. MAC addresses stay the
same across a nonstop forwarding failover so that neighbors do not need to relearn them.
continuously checkpoint (that is, forward) information to the backup unit. Changes to the
running configuration are automatically copied to the backup unit. MAC addresses stay the
same across a nonstop forwarding failover so that neighbors do not need to relearn them.
Format
no boot auto-copy-sw allow-downgrade
Mode
Privileged EXEC
Format
show auto-copy-sw
Mode
Privileged EXEC
Term
Definition
Synchronization
Shows whether the SFS feature is enabled.
SNMP Trap Status
Shows whether the stack sends traps for SFS events
Allow Downgrade
Shows wether the stack manager is permitted to downgrade the firmware version of a
stack member.