Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Guia Do Programa
Switching Commands
487
M4200 and M4300 Series ProSAFE Managed Switches
Command example:
(NETGEAR Switch) #show mvrp statistics summary
MVRP messages received......................... 45
MVRP messages received with bad header......... 0
MVRP messages received with bad format......... 0
MVRP messages transmitted...................... 16
MVRP messages failed to transmit............... 0
MVRP Message Queue Failures.................... 0
Command example:
(NETGEAR Switch) #show mvrp statistics 0/12
Port........................................... 0/12
MVRP messages received......................... 21
MVRP messages received with bad header......... 0
MVRP messages received with bad format......... 0
MVRP messages transmitted...................... 8
MVRP messages failed to transmit............... 0
MVRP failed reservations....................... 0
Port-Channel/LAG (802.3ad) Commands
This section describes the commands you use to configure port-channels, which is defined in
the 802.3ad specification, and that are also known as link aggregation groups (LAGs). Link
aggregation allows you to combine multiple full-duplex Ethernet links into a single logical link.
Network devices treat the aggregation as if it were a single link, which increases fault
tolerance and provides load sharing. The LAG feature initially load shares traffic based upon
the source and destination MAC address. Assign the port-channel (LAG) VLAN membership
after you create a port-channel. If you do not assign VLAN membership, the port-channel
might become a member of the management VLAN which can result in learning and
switching issues.
the 802.3ad specification, and that are also known as link aggregation groups (LAGs). Link
aggregation allows you to combine multiple full-duplex Ethernet links into a single logical link.
Network devices treat the aggregation as if it were a single link, which increases fault
tolerance and provides load sharing. The LAG feature initially load shares traffic based upon
the source and destination MAC address. Assign the port-channel (LAG) VLAN membership
after you create a port-channel. If you do not assign VLAN membership, the port-channel
might become a member of the management VLAN which can result in learning and
switching issues.
A port-channel (LAG) interface can be either static or dynamic, but not both. All members of a
port channel must participate in the same protocols.) A static port-channel interface does not
require a partner system to be able to aggregate its member ports.
require a partner system to be able to aggregate its member ports.
Parameter
Description
summary
If used with the summary parameter, the command shows global MVRP statistics.
interface
If the unit/slot/port is specified, the command shows MVRP statistics for that interface.
all
If used with the all parameter, the command shows a table containing MVRP statistics for all
interfaces on which MVRP is enabled.
interfaces on which MVRP is enabled.