Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Guia Do Programa

(NETGEAR Switch)# show vlan remote-span

Remote SPAN VLAN

------------------------------------------------------------------------

100

The commands in this section describe how to configure static MAC filtering. Static MAC 
filtering allows you to configure destination ports for a static multicast MAC filter irrespective 
of the platform. 

This command adds a static MAC filter entry for the MAC address macaddr on the VLAN 
vlanid

. A packet with a specific destination MAC address in a specific VLAN is admitted 

only if the ingress port is defined in the set of source ports, otherwise the packet is dropped.

On the egress side, a packet that was admitted is sent through all ports that are defined in 
the set of destination ports.

The value of the macaddr parameter is a 6-byte hexadecimal number in the format of 
b1:b2:b3:b4:b5:b6. The restricted MAC Addresses are: 00:00:00:00:00:00, 
01:80:C2:00:00:00 to 01:80:C2:00:00:0F, 01:80:C2:00:00:20 to 01:80:C2:00:00:21, and 
FF:FF:FF:FF:FF:FF. The vlanid parameter must identify a valid VLAN. 

The number of static mac filters supported on the system is different for MAC filters where 
source ports are configured and MAC filters where destination ports are configured. 

For unicast MAC address filters and multicast MAC address filters with source port lists, 
the maximum number of static MAC filters supported is 20.

For multicast MAC address filters with destination ports configured, the maximum number 
of static filters supported is 256.

For example, you can configure the following combinations:

Unicast MAC and source port (max = 20)

Multicast MAC and source port (max = 20)

Multicast MAC and destination port (only) (max = 256)

Multicast MAC and source ports and destination ports (max = 20)

Format

macfilter macaddr vlanid

Mode

Global Config