Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Guia Do Programa

IPv6 management commands allow a device to be managed via an IPv6 address in a switch 
or through IPv4 routing (that is, independent from the IPv6 routing package). For 
Routing/IPv6 builds of NETGEAR Managed Switch software, dual IPv4/IPv6 operation over 
the service port is enabled. NETGEAR Managed Switch software provides capabilities such 
as the following”

Static assignment of IPv6 addresses and gateways for the service/network ports.

The ability to ping an IPv6 link-local address over the service/network port.

Using IPv6 management commands, you can send SNMP traps and queries via the 
service/network port.

The user can manage a device via the network port (in addition to a Routing Interface or 
the Service port). 

Use this command to create an IPv6 management interface, enable IPv6 and DHCPv6 on 
the management interface, and delete a previous IPv6 management interface, if there was 
any. (The switch does not provide a default IPv6 management interface.)

Use this command to reset the IPv6 management interface to the default settings, that is, 
remove the IPv6 management interface. (The switch does not provide a default IPv6 
management interface.)

Use this command to enable IPv6 operation on the service port. By default, IPv6 operation is 
enabled on the service port.

Format

ipv6 management {vlan number | port unit/slot/port} {autoconfig | 

dhcp | prefix prefix-length}

Mode

Global Config

Format

no ipv6 management

Mode

Global Config

Default

enabled

Format

serviceport ipv6 enable

Mode

Privileged EXEC