Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Guia Do Programa
Routing Commands
632
M4200 and M4300 Series ProSAFE Managed Switches
show arp switch (Address Resolution Protocol commands)
This command displays the contents of the switch’s Address Resolution Protocol (ARP)
table.
table.
IP Routing Commands
This section describes the commands you use to enable and configure IP routing on the
switch.
switch.
autostate
This command enables AutoState for a VLAN routing interface. AutoState changes the state
of a VLAN routing interface automatically based on link state events (up or down).
of a VLAN routing interface automatically based on link state events (up or down).
By default, AutoState is disabled, which means that a VLAN routing interface could remain up
even if the link is down.
even if the link is down.
no autostate
This command disables AutoState for a VLAN routing interface.
Total Entry Count
Current / Peak
Current / Peak
The total entries in the ARP table and the peak entry count in the ARP table.
Static Entry Count
Current / Max
Current / Max
The static entry count in the ARP table and maximum static entry count in the ARP table.
Format
show arp switch
Mode
Privileged EXEC
Term
Definition
IP Address
The IP address of a device on a subnet attached to the switch.
MAC Address
The hardware MAC address of that device.
Interface
The routing unit/slot/port associated with the device’s ARP entry.
Format
autostate
Mode
Interface Config
Format
no autostate
Mode
Interface Config
Term
Definition