Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Guia Do Programa

This section describes the commands you use to view and configure VLAN routing and to 
view VLAN routing status information.

This command enables routing on a VLAN. The vlanid value has a range from 1 to 4093. 
The interface-id

value has a range from 1 to 128. Typically, you do not supply the 

interface ID argument, and the system automatically selects the interface ID. However, if you 
specify an interface ID, the interface ID becomes the port number in the unit/slot/port 
for the VLAN routing interface. 

If you select an interface ID that is already in use, the CLI displays an error message and 
does not create the VLAN interface. For products that use text-based configuration, including 
the interface ID in the vlan routing command for the text configuration ensures that the 
unit/slot/port

 for the VLAN interface stays the same across a restart. Keeping the 

 the same ensures that the correct interface configuration is applied to 

each interface when the system restarts.

This command deletes routing on a VLAN. 

Ad Mode

The advertise mode, which indicates whether router discovery is enabled or disabled on this 
interface.

Dest Address

The destination IP address for router advertisements.

Max Int 

The maximum advertise interval, which is the maximum time, in seconds, allowed between sending 
router advertisements from the interface.

Min Int 

The minimum advertise interval, which is the minimum time, in seconds, allowed between sending 
router advertisements from the interface.

Hold Time 

The amount of time, in seconds, that a system should keep the router advertisement before 
discarding it.

Preference

The preference of the address as a default router address, relative to other router addresses on the 
same subnet.

Format

vlan routing vlanid [interface-id] 

Mode

VLAN Config

Format

no vlan routing vlanid 

Mode

VLAN Config