Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Guia Do Programa
Routing Commands
715
M4200 and M4300 Series ProSAFE Managed Switches
no trapflags
Use this command to revert to the default reference bandwidth.
•
To disable the individual flag, enter no trapflags and the trapflag group name
followed by the individual flag.
followed by the individual flag.
•
To disable all the flags in that group, enter no trapflags and the trapflag group
name followed by all.
name followed by all.
•
To disable all flags, enter the command as no trapflags all.
OSPF Interface Commands
ip ospf area
Use this command to enable OSPFv2 and set the area ID of an interface or range of
interfaces. The area-id is an IP address formatted as a 4-digit dotted-decimal number or a
decimal value in the range of 0–4294967295. This command supersedes the effects of the
network area
interfaces. The area-id is an IP address formatted as a 4-digit dotted-decimal number or a
decimal value in the range of 0–4294967295. This command supersedes the effects of the
network area
command. It can also be used to configure the advertiseability of the
secondary addresses on this interface into the OSPFv2 domain.
no ip ospf area
Use this command to disable OSPF on an interface.
bandwidth
By default, OSPF computes the link cost of an interface as the ratio of the reference
bandwidth to the interface bandwidth. Reference bandwidth is specified with the auto-cost
command. For the purpose of the OSPF link cost calculation, use the bandwidth command to
specify the interface bandwidth. The bandwidth is specified in kilobits per second; The kbps
argument can be in the range 1–10000000. If no bandwidth is configured, the bandwidth
bandwidth to the interface bandwidth. Reference bandwidth is specified with the auto-cost
command. For the purpose of the OSPF link cost calculation, use the bandwidth command to
specify the interface bandwidth. The bandwidth is specified in kilobits per second; The kbps
argument can be in the range 1–10000000. If no bandwidth is configured, the bandwidth
Format
no trapflags {all | errors {all | authentication-failure | bad-packet |
config-error | virt-authentication-failure | virt-bad-packet |
virt-config-error} | lsa {all | lsa-maxage | lsa-originate} | overflow {all |
lsdb-overflow | lsdb-approaching-overflow} | retransmit {all | packets |
virt-packets} | state-change {all | if-state-change | neighbor-state-change |
virtif-state-change | virtneighbor-state-change}}
Mode
Router OSPF Config
Default
disabled
Format
ip ospf area area-id [secondaries none]
Mode
Interface Config
Format
no ip ospf area [secondaries none]
Mode
Interface Config