Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Guia Do Programa

This section describes the commands you use to configure and view Class of Service (CoS) 
settings for the switch. The commands in this section allow you to control the priority and 
transmission rate of traffic. 

Commands you issue in the Interface Config mode only affect a single 
interface. Commands you issue in the Global Config mode affect all 
interfaces.

This command maps an 802.1p priority to an internal traffic class. The userpriority 
values can range from 0-7. The trafficclass values range from 0-6, although the actual 
number of available traffic classes depends on the platform.

 This command maps each 802.1p priority to its default internal traffic class value. 

This command maps an IP DSCP value to an internal traffic class. The ipdscp

value is 

specified as either an integer from 0 to 63, or symbolically through one of the following 
keywords: af11, af12, af13, af21, af22, af23, af31, af32, af33, af41, af42, af43, be, cs0, cs1, 
cs2, cs3, cs4, cs5, cs6, cs7, ef.

The trafficclass values can range from 0-6, although the actual number of available 
traffic classes depends on the platform.

Format

classofservice dot1p-mapping userpriority trafficclass

Modes

Global Config

Interface Config

Format

no classofservice dot1p-mapping

Modes

Global Config

Interface Config

Format

classofservice ip-dscp-mapping ipdscp trafficclass

Mode

Global Config