Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Guia Do Programa
Quality of Service Commands
972
M4200 and M4300 Series ProSAFE Managed Switches
Command example:
(NETGEAR Switch)# show auto-voip oui-table
OUI Status Description
--------- ---------- ---------
00:01:E3 Default SIEMENS
00:03:6B Default CISCO1
00:01:01 Configured VoIP phone
iSCSI Optimization Commands
This section describes commands you use to monitor iSCSI sessions and prioritize iSCSI
packets. iSCSI Optimization provides a means of giving traffic between iSCSI initiator and
target systems special Quality of Service (QoS) treatment. This is accomplished by
monitoring traffic to detect packets used by iSCSI stations to establish iSCSI sessions and
connections. Data from these exchanges is used to create classification rules that assign the
traffic between the stations to a configured traffic class. Packets in the flow are queued and
scheduled for egress on the destination port based on these rules.
packets. iSCSI Optimization provides a means of giving traffic between iSCSI initiator and
target systems special Quality of Service (QoS) treatment. This is accomplished by
monitoring traffic to detect packets used by iSCSI stations to establish iSCSI sessions and
connections. Data from these exchanges is used to create classification rules that assign the
traffic between the stations to a configured traffic class. Packets in the flow are queued and
scheduled for egress on the destination port based on these rules.
iscsi aging time
This command sets the aging time for iSCSI sessions. Behavior when changing aging time:
•
When aging time is increased, current sessions will be timed out according to the new
value.
value.
•
When aging time is decreased, any sessions that have been dormant for a time
exceeding the new setting will be immediately deleted from the table. All other sessions
will continue to be monitored against the new time out value.
exceeding the new setting will be immediately deleted from the table. All other sessions
will continue to be monitored against the new time out value.
Command example:
The following example sets the aging time for iSCSI sessions to 100 minutes:
(NETGEAR Switch)(config)#iscsi aging time 100
Default
10 minutes
Format
iscsi aging time time
Mode
Global Config
Parameter
Description
time
The number of minutes a session must be inactive prior to its removal. Range: 1-43,200.