Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Guia Do Administrador
CoS Queuing
225
Managed Switches
Show classofservice Trust
The example is shown as CLI commands and as a web interface procedure.
CLI: Show classofservice Trust
To use the CLI to show CoS trust mode, use these commands:
Web Interface: Show classofservice Trust
Select QoS > CoS > Basic > CoS Configuration.
A screen similar to the following displays.
Set classofservice Trust Mode
The example is shown as CLI commands and as a web interface procedure.
CLI: Set classofservice Trust Mode
(Netgear Switch) #show classofservice trust?
<cr> Press Enter to execute the command.
(Netgear Switch) #show classofservice trust
Class of Service Trust Mode: Dot1P
(Netgear Switch) (Config)#classofservice?
dot1p-mapping Configure dot1p priority mapping.
ip-dscp-mapping Maps an IP DSCP value to an internal traffic class.
trust Sets the Class of Service Trust Mode of an Interface.
(Netgear Switch) (Config)#classofservice trust?
dot1p Sets the Class of Service Trust Mode of an Interface
to 802.1p.
ip-dscp Sets the Class of Service Trust Mode of an Interface
to IP DSCP.
(Netgear Switch) (Config)#classofservice trust dot1p?
<cr> Press Enter to execute the command.
(Netgear Switch) (Config)#classofservice trust dot1p