Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Guia Do Administrador
Tunnels for IPv6
525
Managed Switches
Figure 56. 6to4 tunnel configuration
Note:
The following examples do not include the configuration of the IPv4
switch because the 6to4 configuration occurs only in the IPv6 island.
The switch in IPv4 domain does not require any special configuration.
switch because the 6to4 configuration occurs only in the IPv6 island.
The switch in IPv4 domain does not require any special configuration.
CLI: C
reate a 6to4 Tunnel
You must configure Switch1, Switch2, and Switch 3.
CLI: Create a 6to4 Tunnel on Switch 1
1.
Enable routing and IPv6 routing on Switch 1.
2.
Configure IPv4 address on routing port 1/0/1.
(Netgear Switch) # config
(Netgear Switch) (Config)#ipv6 unicast-routing
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#interface 1/0/1
(Netgear Switch) (Interface 1/0/1)#routing
(Netgear Switch) (Interface 1/0/1)#ip address 195.1.3.2 255.255.255.0
(Netgear Switch) (Interface 1/0/1)#exit
Computer 1
Computer 3
Computer 2
Switch 1
Switch 2
Switch 3
IPv4 switch
IPv4 domain
IPv6 island
IPv6 island
IPv6 domain
1/0/3
1/0/1
2/0/1
2/0/3
2/0/24
2/0/1