Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Manual Do Utilizador

You can configure SNMP settings for SNMP V1/V2 and SNMPv3. 

By default, two SNMP communities exist:

Private, with read/write privileges and status set to Enable.

Public, with read-only privileges and status set to Enable.

These are well-known communities. You can change the defaults or to add other 
communities. Only the communities that you define can access to the switch using the SNMP 

Class

The Class defines the range of power a PD is drawing from the system. 
Class definitions: 
0 – 0.44-12.95 (watts) 
1 – 0.44-3.83 (watts) 
2 – 0.44-6.48 (watts) 
3 – 0.44-12.95 (watts) 
4 – 0.44-25.5 (watts) 

Output Voltage

Current voltage being delivered to device in volts.

Output Current

Current being delivered to device in mA.

Output Power

Current power being delivered to device in Watts. 

Status

The status is the operational status of the port PD detection. 

. No power being delivered. 

. Power is being drawn by device. 

. Indicates a problem with the port. 

. The port is in test mode. 

. The port is idle due to error condition. 

. The port is not in one of the above states. 

Fault Status 

Describes the error description when the PSE port is in fault status. 

. The PSE port is not in any error state. 

. The PSE port has detected an absence of main 

power supply. 

. The PSE port has detected a short circuit condition. 

.The PD connected to the PSE port tried to provide more 

power than it is permissible by the hardware. 

. The PSE port was denied power because of 

shortage of power or due to administrative action.