Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Manual Do Utilizador
Configure Switching Information
237
M4200 and M4300 Series ProSAFE Managed Switches Web Management User Manual
Enter a value greater than or equal to 1 and less than the group membership interval in
seconds. The default is 10 seconds. The configured value must be less than the group
membership interval.
seconds. The default is 10 seconds. The configured value must be less than the group
membership interval.
10.
Use Present Expiration Time to specify the amount of time you want the switch to wait to
receive a query on an interface before removing it from the list of interfaces with multicast
routers attached.
Enter a value between 0 and 3600 seconds. The default is 0 seconds. A value of zero
indicates an infinite time-out, that is, no expiration.
indicates an infinite time-out, that is, no expiration.
11.
Fast Leave Admin Mode
is the administrative mode of Fast Leave on the interface.
If Fast Leave is enabled, the interface can be immediately removed from the Layer 2
forwarding table entry upon receiving an MLD leave message for a multicast group
without first sending out MAC-based general queries. The default is Disable.
forwarding table entry upon receiving an MLD leave message for a multicast group
without first sending out MAC-based general queries. The default is Disable.
12.
Select Enable or Disable for the Proxy Querier Mode for a particular interface.
If the mode is disabled, an MLD proxy query with source IP 0::0 is not sent in response to
an MLD leave packet. If the mode is enabled, MLD proxy queries are sent. The default
value is Enable.
an MLD leave packet. If the mode is enabled, MLD proxy queries are sent. The default
value is Enable.
13.
Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
immediately.
Configure MLD VLAN Settings
To configure MLD VLAN settings:
1.
Launch a web browser.
2.
Enter http://<ipaddress> in the web browser address field.
The login window opens.
3.
Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
do not enter a password.
4.
Click the Login button.
The System Information page displays.
5.
Select Switching
> Multicast > MLD Snooping > MLD VLAN Configuration.