Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Manual Do Utilizador
Maintenance and Troubleshooting
669
M4200 and M4300 Series ProSAFE Managed Switches Web Management User Manual
The range is 1 to 15. The default value is 3.
9.
Enter the Interval in seconds between ping packets.
The range is 1 to 60. The default value is 3.
10.
Use Datagram Size to enter the datagram size.
The valid range is 0 to 13000. The default value is 0 bytes.
11.
Enter the Source IP address or interface to use when sending the echo request packets.
If the source is not required, select None as the source option. Possible values are as
follows:
follows:
•
None
. The source address of the ping packet would be the address of the default
outgoing interface.
•
IPv6 Address
. The source IPv6 address to use when sending the echo request
packets. This field is shown when IPv6 Address is selected as the source option.
•
Interface
. The interface to use when sending the echo request packets. This field is
shown when Interface is selected as the source option.
Note:
Values configured in the fields on this page are not saved to the switch.
As a result, refreshing the page sets these fields to the default values.
As a result, refreshing the page sets these fields to the default values.
12.
Click the Apply button.
Pings are sent to the specified IPv6 address or host name. The switch sends the number
of pings specified in the Count field, and the results are displayed below the configurable
data in the Results area.
of pings specified in the Count field, and the results are displayed below the configurable
data in the Results area.
Traceroute IPv4
Use this page to tell the switch to send a traceroute request to a specified IP address or host
name. You can use this to discover the paths packets take to a remote destination. Once you
click the Apply button, the switch sends traceroute and the results are displayed below the
configurable data.
name. You can use this to discover the paths packets take to a remote destination. Once you
click the Apply button, the switch sends traceroute and the results are displayed below the
configurable data.
If a reply to the traceroute is received, the following message displays:
1 e.f.g.h 9869 usec 9775 usec 10584 usec
2 0.0.0.0 0 usec * 0 usec * 0 usec *
3 0.0.0.0 0 usec * 0 usec * 0 usec *
Hop Count = j Last TTL = k Test attempt = m Test Success = n.
To configure the traceroute settings and send probe packets to discover the route to a
host on the network:
host on the network:
1.
Launch a web browser.
2.
Enter http://<ipaddress> in the web browser address field.
The login window opens.