Netgear GS752TPS(B) - ProSAFE 48-Port Gigabit Stackable Smart Switch with PoE and 4 SFP uplinks Manual Do Equipamento

Step 1: Preparing the Site

Before you install the switch, ensure the operating environment meets the site requirements in 
the following table.

Mounting

•  Desktop installations - Provide a flat table or shelf surface.
• Rackmount installations - Use a 19-inch (48.3-centimeter) EIA standard equipment rack that 

is grounded and physically secure. The rackmount kit supplied with the switch is also required. 

Access

Locate the switch in a position that allows you to access the front-panel RJ-45 ports, view the 
front-panel LEDs, and access the power connector.

Power source

. 

Ensure the AC outlet is not controlled by a wall switch, which can accidentally turn off power to 
the outlet and the switch.

Environmental

• Temperature - Install the switch in a dry area, with ambient temperature between 0 and 50ºC 

(32ºF and 122ºF). Keep the switch away from heat sources such as direct sunlight, warm air 
exhausts, hot-air vents, and heaters.

• Operating humidity - The installation location should have a maximum relative humidity of 10 

to 90%, non-condensing.

• Ventilation - Do not restrict airflow by covering or obstructing air inlets on the sides of the 

switch. Keep at least 2 inches (5.08 centimeters) free on all sides for cooling. Be sure there is 
adequate airflow in the room or wiring closet where the switch is installed.

• Operating conditions - Keep the switch at least 6 ft. (1.83 meters) away from nearest source 

of electromagnetic noise, such as a photocopy machine.

Step 2: Installing the Switch

The GS728TS, GS728TPS, GS752TS, and GS752TPS Smart Switch can be used on a flat 
surface or mounted in a standard network equipment rack.

Installing the Switch on a Flat Surface

The switch ships with four self-adhesive rubber footpads. Stick one rubber footpad on each of 
the four concave spaces on the bottom of the switch. The rubber footpads cushion the switch 
against shock and vibrations. They also provide ventilation space between stacked switches.

Installing the Switch in a Rack

To install the switch in a rack, you need the 19-inch rackmount kit supplied with the switch.

Attach the supplied mounting brackets to the side of the switch. 

Insert the screws provided in the rackmount kit through each bracket and into the bracket 

mounting holes in the switch. 

Tighten the screws with a #1 Phillips screwdriver to secure each bracket.