Netgear GS752TPS(B) - ProSAFE 48-Port Gigabit Stackable Smart Switch with PoE and 4 SFP uplinks Guia Do Programa

Trap Flags

The pages in the Trap Manager folder allow you to view and configure information about 
SNMP traps the system generates.

Use the Trap Flags page to enable or disable traps the switch can send to an SNMP 
manager. When the condition identified by an active trap is encountered by the switch, a trap 
message is sent to any enabled SNMP Trap Receivers, and a message is written to the trap 
log.

To access the Trap Flags page, click System > SNMP > SNMP V1/V2 > Trap Flags. 

To configure the trap flags:

From the Authentication field, enable or disable activation of authentication failure 
traps by selecting the corresponding button. The factory default is Enable.

From the Link Up/Down field, enable or disable activation of link status traps by selecting 
the corresponding button. The factory default is Enable.

From the Spanning Tree field, enable or disable activation of spanning tree traps by 
selecting the corresponding button. The factory default is Enable.

For the GS728TPS and GS752TPS switches, use the PoE field to enable or disable 
activation of PoE traps. The factory default is Enable.

If you make any changes to this page, click Apply to send the updated configuration to the 
switch. Configuration changes take effect immediately.

Click Cancel to cancel the configuration on the screen and reset the data on the screen to 
the latest value of the switch.