Netgear S3300-28X (GS728TX) - ProSAFE S3300 Smart Switch Series Guia Do Administrador

Click the box under each port or LAG to add to the VLAN as a VLAN member.

Each port or LAG has three modes:

T(Tagged). Select the ports on which all frames transmitted for this VLAN will be 
tagged. The ports that are selected will be included in the VLAN.

U(Untagged). Select the ports on which all frames transmitted for this VLAN will be 
untagged. The ports that are selected will be included in the VLAN.

BLANK(Autodetect). Select the ports that can be dynamically registered in this 
VLAN via GVRP. This selection has the effect of excluding a port from the selected 
VLAN.

Click the Apply button.

Use the VLAN Routing Configuration screen to view information about the VLAN routing 
interfaces configured on the system or to assign an IP address and subnet mask to VLANs 
on the system.



Select Routing 



 VLAN > VLAN Routing.

From the VLAN list, select the VLAN you want to configure for VLAN routing. 

This field will display the all IDs of VLANs configured on this switch.

Enter an IP address of the VLAN routing interface.

Enter a subnet mask for the VLAN routing interface.

In the IP MTU field, specify the maximum size of IP packets sent on an interface. 

A valid range is from 68 bytes to the link MTU. The default value is 1500. A value of 0 

indicates that the IP MTU is unconfigured. When the IP MTU is unconfigured, the router 
uses the link MTU as the IP MTU. The link MTU is the maximum frame size minus the 
length of the layer 2 header. 

Click the Add button.

The following table describes the VLAN routing interface status information available on the 
screen. 

Port

The port number assigned to the VLAN Routing Interface. 

MAC Address

The MAC Address assigned to the VLAN Routing Interface.