Netgear XS728T – ProSAFE® 10 Gigabit Smart Managed Switch Manual Do Equipamento
Installation
19
XS728T Smart Managed Switch
Figure 7. Connecting devices to the switch
Note:
Ethernet specifications limit the cable length between the switch and
the attached device to 328 feet (100 meters).
the attached device to 328 feet (100 meters).
To connect devices to the switch:
Using a Category 5 (CAT 5) unshielded twisted-pair (UTP) cable terminated with an
RJ-45 connector, connect each computer to an RJ-45 network port on the switch front
panel.
RJ-45 connector, connect each computer to an RJ-45 network port on the switch front
panel.
See the previous figure.
Note:
For 10GBASE-T connections, and in particular for connections over
100 feet (30 meters), NETGEAR recommends that you use a
Category 6a cable or a higher-rated cable.
100 feet (30 meters), NETGEAR recommends that you use a
Category 6a cable or a higher-rated cable.
Step 5: Install an SFP+ Transceiver Module
The following procedure describes how to install an optional SFP+ or SFP transceiver
module into one of the SFP+ ports of the switch.
module into one of the SFP+ ports of the switch.
Note:
Contact your NETGEAR sales office to buy these modules. If you do
not want to install an SFP+ or SFP module, skip this procedure.
not want to install an SFP+ or SFP module, skip this procedure.
To install an SFP+ or SFP transceiver:
1.
Insert the transceiver into the SFP+ port.