Netgear S3300-28X-PoE+ (GS728TXP) - ProSAFE S3300 Smart Switch Series Manual Do Equipamento



Connect the end of the power cord to the power receptacle on the back of the smart 
switch.

Plug the AC power cord into a power source such as a wall socket or power strip.

When you apply power, the Power LED on the smart switch’s front panel lights.

If the Power LED does not light, check that the power cord is plugged in correctly and that the 
power source is good. If the problem remains, see 

.

This step is optional for models S3300-52X-PoE+ and S3300-28X-PoE+ only. These models 
support an optional external redundant power supply (RPS).



Loosen the screws of the RPS cover plate and remove the cover plate.

The RPS receptacle is exposed.

Plug in the RPS connector.

Plug the AC power cord of the RPS into a power source such as a wall socket or power 
strip.

The smart switch contains software for viewing, changing, and monitoring the way it works. 
This management software is not required for the smart switch to work. You can use the 
ports without using the management software. However, the management software enables 
the setup of VLAN and trunking features and also improves the efficiency of the smart switch, 
which results in the improvement of its overall performance as well as the performance of the 
network. 

After you power up the smart switch for the first time, you can configure the smart switch 

using a web browser or a program called Smart Control Center. For more information about 
managing the smart switch, see the S3300 Smart Switch Software Administration Manual. 
The resource CD includes a link to this document.

The smart switch is configured with a default IP address of 
192.168.0.239 and a subnet mask of 255.255.255.0.