Netgear S3300-28X-PoE+ (GS728TXP) - ProSAFE S3300 Smart Switch Series Guia Do Administrador
Configure System Information
66
S3300 Smart Switch
Note:
NETGEAR recommends assigning the highest priority value to the
switch that you prefer to be the stack manager. This ensures that the
switch is re-elected as stack manager if a re-election occurs.
switch that you prefer to be the stack manager. This ensures that the
switch is re-elected as stack manager if a re-election occurs.
•
The switch with the higher MAC address
A stack manager retains its role unless one of these events occurs:
•
The stack manager is removed from the switch stack
•
The stack manager is reset or powered off
•
The stack manager has failed
•
The switch stack membership is increased by adding powered-on standalone switches or
switch stacks
switch stacks
In the case of a manager re-election, the new stack manager becomes available after a few
seconds.
seconds.
If a new stack manager is elected and the previous stack manager becomes available, the
previous stack manager does not resume its role as stack manager.
previous stack manager does not resume its role as stack manager.
Basic Stack Configuration
Use the Stack Configuration screen to move the Primary Management Unit functionality
from one unit to another. When applied, the entire stack (including all interfaces in the stack)
is unconfigured and reconfigured with the configuration on the new Primary Management
Unit. After the reload is complete, all stack management capability must be performed on the
new Primary Management Unit. To preserve the current configuration across a stack move,
save the current configuration to the nvram before performing the stack move. A stack move
causes all routes and Layer 2 addresses to be lost. The system prompts the administrator to
confirm the management move before the changes are applied.
from one unit to another. When applied, the entire stack (including all interfaces in the stack)
is unconfigured and reconfigured with the configuration on the new Primary Management
Unit. After the reload is complete, all stack management capability must be performed on the
new Primary Management Unit. To preserve the current configuration across a stack move,
save the current configuration to the nvram before performing the stack move. A stack move
causes all routes and Layer 2 addresses to be lost. The system prompts the administrator to
confirm the management move before the changes are applied.
Management Unit Selection
To do basic stack configuration:
1.
Click System
Stacking > Basic > Stack Configuration.
2.
Select the Management Unit. The Management Unit Selected field displays the Current
Primary Management Unit. You can change it by selecting another unitID listed here.
Primary Management Unit. You can change it by selecting another unitID listed here.
3.
Click the Cancel button to cancel the configuration on the screen and reset the data on the
screen to the latest value of the switch.
screen to the latest value of the switch.
4.
Click the Apply button to send the updated configuration to the switch. Configuration
changes take effect immediately.
changes take effect immediately.
Note:
The Move Management operation may cause a change in the system
IP address when the IP address is assigned by a DHCP server.
IP address when the IP address is assigned by a DHCP server.