Netgear XS728T – ProSAFE® 10 Gigabit Smart Managed Switch Guia Do Administrador
System
19
XS728T ProSAFE 28-Port 10-Gigabit L2+ Smart Switch
•
IP Address. The IP address of the network interface. The factory default value is
192.168.0.239. Each part of the IP address must start with a number other than 0. For
example, IP addresses 001.100.192.6 and 192.001.10.3 are not valid.
192.168.0.239. Each part of the IP address must start with a number other than 0. For
example, IP addresses 001.100.192.6 and 192.001.10.3 are not valid.
•
Subnet Mask. The IP subnet mask for the interface. The factory default value is
255.255.255.0.
255.255.255.0.
•
Default Gateway. The default gateway for the IP interface. The factory default IP
address assigned to the default gateway is 192.168.0.254.
address assigned to the default gateway is 192.168.0.254.
4.
Specify the VLAN ID for the management VLAN.
The management VLAN is used to establish an IP connection to the switch from a
workstation that is connected to a port in the same VLAN. If not specified, the active
management VLAN ID is 1 (default), which allows an IP connection to be established
through any port.
workstation that is connected to a port in the same VLAN. If not specified, the active
management VLAN ID is 1 (default), which allows an IP connection to be established
through any port.
When the management VLAN is set to a different value, an IP connection can be made
only through a port that is part of the management VLAN. It is also mandatory that the
port VLAN ID (PVID) of the port to be connected in that management VLAN be the same
as the management VLAN ID.
only through a port that is part of the management VLAN. It is also mandatory that the
port VLAN ID (PVID) of the port to be connected in that management VLAN be the same
as the management VLAN ID.
Note:
Make sure that the PVID of at least one port that is a port of the VLAN
is the same as the management VLAN ID. For information about
creating VLANs and configuring the PVID for a port, see
is the same as the management VLAN ID. For information about
creating VLANs and configuring the PVID for a port, see
VLAN
on
page
53.
The management VLAN has the following requirements:
•
Only one management VLAN can be active at a time.
•
When a new management VLAN is configured, connectivity through the existing
management VLAN is lost.
management VLAN is lost.
•
The management station must be reconnected to the port in the new management
VLAN.
VLAN.
5.
Click Apply to apply the changes to the system.
IPv6 Network Configuration
Use the IPv6 Network Configuration screen to configure the IPv6 network interface, which is
the logical interface used for in-band connectivity with the switch through any of the switch's
front-panel ports. The configuration parameters associated with the switch's network
interface do not affect the configuration of the front-panel ports through which traffic is
switched or routed.
the logical interface used for in-band connectivity with the switch through any of the switch's
front-panel ports. The configuration parameters associated with the switch's network
interface do not affect the configuration of the front-panel ports through which traffic is
switched or routed.
To access the switch over a IPv6 network, you must initially configure the switch with IPv6
information (IPv6 prefix, prefix length, and default gateway). IPv6 can be configured using
IPv6 auto configuration.
information (IPv6 prefix, prefix length, and default gateway). IPv6 can be configured using
IPv6 auto configuration.