Netgear GS748Tv5 - ProSAFE 48-port Gigabit Smart Switch Guia Do Administrador

Optionally, configure the following settings:

In the Count field, specify the number of pings to send.

In the Interval (secs) field, specify the number of seconds between pings sent.

In the Datagram Size field, specify the size of the ping packet.

In the Source field, select the source type from which the ping is sent, which is one of 
the following:

None. The source is the IP address of the default outgoing interface.

IP address. The source is an IP address that you specify. If you select this option, 

the IP Address field appears. Specify the source IP address of the ping in the IP 
address field.

Interface. The ping is sent from a specified interface. If you select this option, the 
Interface field appears. Use the menu to select the interface from which to send 
the ping.

Click the Apply button. 

The switch sends the number of pings specified in the Count field, and the results are 
displayed below the configurable data in the Result area:

If the ping is successful, the output is “Send count=3, Receive count = n from (IPv6 
Address).Average round trip time = n ms”.

If a reply to the ping is not received, the following displays: “Reply From IP/Host: 
Destination Unreachable. Tx = x, Rx = 0 Min/Max/Avg RTT = 0/0/0 msec.”

Use the traceroute utility to discover the paths that an IPv4 packet takes to a remote 
destination.



Select Maintenance 

>

>

 TraceRoute IPv4.

In the IP Address/Hostname field, specify the IP address or the host name of the station to 
which the switch should find a path. 

The initial value is blank. This information is not retained across a power cycle.

Optionally, configure the following settings:

Probes Per Hop. Specify the number of times each hop should be probed.

MaxTTL. Specify the maximum time-to-live for a packet in number of hops.

InitTTL. Specify the initial time-to-live for a packet in number of hops.

MaxFail. Specify the maximum number of failures allowed in the session.

Interval. Specify the number of seconds between probes.

Port. Specify the UDP destination port in the probe packets.

Size. Specify the size of the probe packets.