Netgear GS752TP - 52PT GE POE SMART SWITCH Guia Do Administrador

STP Status. Enable or disable the Spanning Tree Protocol administrative mode 
associated with the port or port channel.

Fast Link. Specifies if the specified port is an edge port with the CST. Possible values 
are Auto, Enable, or Disable. The default is Auto, which specifies that the software 
waits for 3 seconds (with no BPDUs received on the interface) before putting the 
interface into the PortFast mode.

BPDU Forwarding. Specifies whether spanning tree BPDUs should be forwarded 
while spanning-tree is disabled on the switch. Select Enable or Disable.

Port State. The forwarding state of this port. This field is read-only.

Path Cost. Set the Path Cost to a new value for the specified port in the Common 
and Internal Spanning Tree. The valid range is 1–200000000.

Priority. The priority for a particular port within the CST. The port priority is set in 
multiples of 16. If you specify a value that is not a multiple of 16, the priority is 
automatically set to the next lowest priority that is a multiple of 16. For example, if you 
set a value from 0 through 15, the priority is set to 0. If you specify a number from 16 
through 31, the priority is set to 16.

Port ID. The port identifier for the specified port within the CST. It is made up from the 
port priority and the interface number of the port.

Hello Timer. Specifies the switch hello time, which indicates the amount of time in 
seconds a port waits between configuration messages. The value is fixed at 2 
seconds. 

Click APPLY to send the updated configuration to the switch.

Configuration changes take place immediately.

To display Common Spanning Tree (CST) and Internal Spanning Tree on a specific port on 
the switch, use the CST Port Status screen.