Netgear GS728TPP – 28PT GE POE+ SMART SWITCH Guia Do Administrador

Committed Rate. The committed rate is the average bandwidth in bits per seconds 
specified in kilobits-per-second (Kbps) and is an integer from 100 to 1000000.

Committed Burst Size. The committed burst size is the maximum amount of traffic 
allowed in one burst (in bytes) and is an integer from 3000 to 19173960.

The Token Bucket algorithm is used, in which the committed rate is 
the rate at which the bucket is filled, and the committed burst size is 
the size of the bucket. This means that the committed burst size is the 
maximum size of a burst that can be sent.

Conform Action. Determines what happens to packets that are considered 
conforming (below the police rate). Select one of the following actions:

Send. (Default) These packets are presented unmodified by DiffServ to the 
system forwarding element.

Drop. These packets are immediately dropped.

Mark CoS. These packets are marked by DiffServ with the specified CoS value 
before being presented to the system forwarding element. This selection requires 
that the Mark CoS value field be set. 

Mark IP DSCP. These packets are marked by DiffServ with the specified DSCP 
value before being presented to the system forwarding element. This selection 
requires that the DSCP value field be set. If you select Other, enter a custom 
value in the DSCP Value field that appears.

Violate Action. Determines what happens to packets that are considered 
non-conforming (above the police rate). Select one of the following actions:

Send. These packets are presented unmodified by DiffServ to the system 
forwarding element.

Drop. These packets are immediately dropped.

Click APPLY to send the updated configuration to the switch. 

Configuration changes take effect immediately.

Use the Service Configuration screen to activate a policy on an interface. 



Select QoS 







 Service Configuration.