Netgear FS526Tv2 - 24-Port Smart Switch with Gigabit Ports Guia Do Utilizador
Configure Class of Service
142
ProSAFE FS526Tv2, FS726Tv2, and FS728TLP Smart Switches
Configure CoS on Ports and LAGs
You can configure the trust mode for individual interfaces and LAGs on the CoS
Configuration screen, but you can also do this on the CoS Interface Configuration screen,
which gives you more configuration flexibility and lets you also configure the interface
shaping rate.
Configuration screen, but you can also do this on the CoS Interface Configuration screen,
which gives you more configuration flexibility and lets you also configure the interface
shaping rate.
The shaping rate is typically used to shape the outbound transmission rate in increments of
64 kbps. This shaping rate is controlled independently of any per-queue maximum bandwidth
configuration and is effectively a second-level shaping mechanism. By default, the shaping
rate is 0, which disables traffic shaping.
64 kbps. This shaping rate is controlled independently of any per-queue maximum bandwidth
configuration and is effectively a second-level shaping mechanism. By default, the shaping
rate is 0, which disables traffic shaping.
The expected shaping at the egress interface is calculated in the following manner:
frameSize * shaping * 64/(64+20)
frameSize is the configured frame size and shaping is the configured traffic shaping rate.
For example, when a frame size of 64 bytes and a shaping rate of 64 kbps are configured,
expected shaping is approximately 3121 kbps.
expected shaping is approximately 3121 kbps.
To configure the trust mode and shaping rate for one or more ports and LAGs:
1.
Select the QoS > Advanced > CoS Interface Configuration.
The CoS Interface Configuration screen displays. The following figure does not show all
ports.
ports.