Netgear WAC720- ProSAFE® Business 2 x 2 Dual Band Wireless-AC Access Point Manual Do Utilizador
Advanced Configuration
122
ProSAFE Dual-Band Wireless AC Access Points WAC720 and WAC730
5.
Select the Enable radio button.
6.
Click the Apply button.
Your settings are saved.
IMPORTANT:
Before you can use a captive portal that you configured, you must
select the captive portal instance for a WiFi security profile (see
select the captive portal instance for a WiFi security profile (see
on page 38). After you
do so, the WiFi network that is associated with the WiFi security
profile becomes accessible only through the captive portal.
profile becomes accessible only through the captive portal.
Configure WiFi Bridging
The access point supports a wireless distribution system (WDS) that lets you build large
bridged WiFi networks.
bridged WiFi networks.
Point-to-Point Bridge and Point-to-Multipoint Bridge
You can set up a single point-to-point bridge or create a point-to-multipoint bridge by setting
up to four point-to-point bridges with your access point functioning as the master:
up to four point-to-point bridges with your access point functioning as the master:
•
WiFi point-to-point bridge. The access point communicates with another bridge-mode
access point and with WiFi clients. You can use WPA2-PSK to secure the
communication. The following figure shows an example in which two access points (APs)
function in point-to-point bridge mode.
access point and with WiFi clients. You can use WPA2-PSK to secure the
communication. The following figure shows an example in which two access points (APs)
function in point-to-point bridge mode.