Netgear WAC720- ProSAFE® Business 2 x 2 Dual Band Wireless-AC Access Point Manual Do Utilizador

If the path is not working, you see this message:

Request timed out

If the path is not functioning correctly, one of the following problems could be occurring:

Make sure that the

Active LED and LAN LED are on. If one or both of these LEDs 

are off, follow the instructions in 

Check to see that the corresponding link LEDs are on for your network interface 
card and for the hub ports (if any) that are connected to your workstation and 
access point.

Wrong network configuration:

Verify that the Ethernet card driver software and TCP/IP software are both 
installed and configured on your computer.

Verify that the IP address for your access point and your workstation are correct 
and that the addresses are on the same subnet.

After verifying that the LAN path works correctly, test the path from your computer to a remote 

device. 

From the Windows toolbar, click the Start button, and select Run.

In the Windows Run window, type

 <IP address>

where <IP address> is the IP address of a remote device such as the DNS server of 
your ISP.

If the path is functioning correctly, replies as in 

page 131 display. If you do not receive replies, do the following:

Check to see that the IP address of your access point is listed as the IP address of the 
default router in your computer. If the IP configuration of your computer is assigned by 
DHCP, this information is not visible in your computer’s Network Control Panel. Verify that 
the IP address of the access point is listed as the IP address of the default router.

Check to see that the network address of your computer (the portion of the IP address 
specified by the netmask) is different from the network address of the remote device.

Check to see that your cable or DSL modem is connected and functioning.

If your ISP assigned a host name to your computer, enter that host name as the account 
name on the basis General system settings page (see