Netgear FS516 - 16 Port 10/100 Mbps Fast Ethernet Switch Guia Da Instalação
Installation Guide for the Model FS516 Fast Ethernet Switch
5-2
Troubleshooting
Network Adapter Cards
Make sure the network adapter cards installed in the PCs are in working condition and the software
driver has been installed.
driver has been installed.
Configuration
If problems occur after altering the network configuration, restore the original connections and
determine the problem by implementing the new changes, one procedure at a time. Make sure
that cable distances, repeater limits, and other physical aspects of the installation do not exceed
the Ethernet limitations.
determine the problem by implementing the new changes, one procedure at a time. Make sure
that cable distances, repeater limits, and other physical aspects of the installation do not exceed
the Ethernet limitations.
Switch Integrity
If required, verify the integrity of the switch by resetting the switch. Turn power to the switch off
and then back on. If the problem continues and you have completed all the preceding diagnoses,
contact your NETGEAR point-of-sale representative.
and then back on. If the problem continues and you have completed all the preceding diagnoses,
contact your NETGEAR point-of-sale representative.
One or more components
are malfunctioning.
are malfunctioning.
All system components
are not properly installed.
are not properly installed.
Test the components in an alternate environment
where all other components are functioning
properly.
where all other components are functioning
properly.
A segment or device is
not recognized as part of
the network.
not recognized as part of
the network.
One or more devices are
not properly connected or
cabling does not meet
Ethernet guidelines.
not properly connected or
cabling does not meet
Ethernet guidelines.
Verify that the cabling is correct (refer to
). Be sure all
cable connectors are securely positioned in the
required ports. Straight-through cables should be
used for all standard twisted pair connections.
Make sure all devices are connected to the
network. Equipment may have been accidentally
disconnected.
required ports. Straight-through cables should be
used for all standard twisted pair connections.
Make sure all devices are connected to the
network. Equipment may have been accidentally
disconnected.
Table 5-1.
Troubleshooting Information (continued)
Symptom
Cause
Solution