Netgear GS716Tv2 - ProSAFE 16-Port Gigabit Managed Switch Guia Do Administrador

Click Apply to send the ping. The switch sends the number of pings specified in the Count 

field, and the results are displayed below the configurable data in the Result area. 

If successful, the output will be Send count=3, Receive count = n from (IPv6 
Address).Average round trip time = n ms.

If a reply to the ping is not received, the following displays: “Reply From IP/Host: 
Destination Unreachable. Tx = x, Rx = 0 Min/Max/Avg RTT = 0/0/0 msec”.

Traceroute

Use the Traceroute utility to discover the paths that a packet takes to a remote destination.

To display this page, click Maintenance 





 Traceroute.

 

To configure the Traceroute settings and send probe packets to discover the route to a host 
on the network:

In the Hostname/IP Address field, specify the IP address or the hostname of the 

station you want the switch to ping. The initial value is blank. This information is not 

retained across a power cycle.

Optionally, configure the following settings:

Probes Per Hop. Specify the number of times each hop should be probed. The valid 
range is 1–10.

MaxTTL. Specify the maximum time-to-live for a packet in number of hops. The valid 
range is 1–255.