Netgear MS2120 - STORA (2TB: 1X2TB) Manual Do Utilizador

Connect Stora to Your Network

The initial setup completion time is approximately 20 minutes. Be sure your unit has ample 
ventilation. Avoid putting the unit in a location where it could be easily knocked over. Do not 
place items on top of Stora, or place liquids near or on top of the unit; the ventilation vents are 
on the top of Stora.



Connect one end of the provided Ethernet cable to your router and the other end to the 
back of Stora unit. 

Plug in the power adapter to a power source and connect the other end to the unit.

When you finish connecting your Stora unit, your network should resemble the following 
figure.

Press the Power button to power up your unit.

The power LED flickers while the unit boots and obtains an IP address; then it turns solid 
blue. The first time you turn the unit on, the disk LEDs are solid amber. After you 
complete the setup, the disk LED indicators are solid green. 

The router in your network needs to have an Ethernet port available 

to connect the Stora unit to the router via the Ethernet cable. Your 
router also needs to be configured to automatically provide an IP 
address for your network devices.

Configure Your Stora

Use the CD that comes with the Stora unit to configure your device and make it ready for 
storing data. At this time you can also give your unit a unique name, and assign your own 
user name and password.

If you do not have the Resource CD, see you can download the setup software from the 
NETGEAR support website.