Netgear FS752TS – ProSAFE 48 Port 10/100 Stackable Smart Switch with 4 Gigabit Ports Manual Do Equipamento

Troubleshooting

A-2

If the suggestions in Troubleshooting Chart do not resolve the problem, refer to the 
troubleshooting suggestions in this section.

Ensure the network adapter cards installed in the PCs are functioning correctly and the latest 
software driver has been installed.

If problems occur after altering the network configuration, restore the original connections and 
determine the problem by implementing the new changes, one step at a time. Ensure that cable 
distances, repeater limits, and other physical aspects of the installation do not exceed the Ethernet 
limitations.

If required, verify the integrity of the switch by resetting the switch. To reset the switch, 
disconnect the AC power from the switch and then reconnect AC source. If the problem continues, 
contact NETGEAR technical support. In North America, call 1-888-NETGEAR. If you are outside 
of North America, please refer to the support information card included with your product.

A segment or device is 
not recognized as part of 
the network.

One or more devices are 
not properly connected, 
or cabling does not meet 
Ethernet guidelines.

Verify that the cabling is correct. Ensure all 
connectors are securely positioned in the required 
ports. Equipment may have been accidentally 
disconnected.

ACT LED is flashing 
continuously on all 
connected ports and the 
network is disabled.

A network loop 
(redundant path) has 
been created.

Break the loop by ensuring that there is only one 
path from any networked device to any other 
networked device.