Netgear M4100-24G-POE+ (GSM7224P) - ProSAFE Gigabit L2+ Managed Switch Guia Do Programa
Utility Commands
333
M4100 Series ProSAFE
Managed
Switches
update bootcode
This command updates the bootcode (boot loader) on the switch. The bootcode is read from
the active-image for subsequent reboots. The optional <unit> parameter is valid only on
Stacks. Error will be returned, if this parameter is provided, on Standalone systems. For
Stacking, the <unit> parameter identifies the node on which this command must be
executed. When this parameter is not supplied, the command is executed on all nodes in a
Stack.
the active-image for subsequent reboots. The optional <unit> parameter is valid only on
Stacks. Error will be returned, if this parameter is provided, on Standalone systems. For
Stacking, the <unit> parameter identifies the node on which this command must be
executed. When this parameter is not supplied, the command is executed on all nodes in a
Stack.
System Information and Statistics Commands
This section describes the commands you use to view information about system features,
components, and configurations.
components, and configurations.
show arp switch (system information and statistics commands)
This command displays the contents of the IP stack’s Address Resolution Protocol (ARP)
table. The IP stack only learns ARP entries associated with the management interfaces
(network or service ports). ARP entries associated with routing interfaces are not listed.
table. The IP stack only learns ARP entries associated with the management interfaces
(network or service ports). ARP entries associated with routing interfaces are not listed.
show eventlog
This command displays the event log, which contains error messages from the system. The
event log is not cleared on a system reset. The <unit> is the switch identifier.
event log is not cleared on a system reset. The <unit> is the switch identifier.
Format
update bootcode [<unit>]
Mode
Privileged EXEC
Format
show arp switch
Mode
Privileged EXEC
Term
Definition
IP Address
IP address of the management interface or another device on the management network.
MAC Address
Hardware MAC address of that device.
Interface
For a service port the output is Management. For a network port, the output is the
slot/port of the physical interface.
slot/port of the physical interface.
Format
show eventlog [<unit>]
Mode
Privileged EXEC