Netgear EDA500 – ReadyNAS Expansion Chassis 5-Bay, Diskless Manual Do Equipamento

A disk LED next to each drive bay indicates the status of the disk inside. The disk
LEDs indicate these states:

Solid blue. Power is on and the disk is operating normally.

Blinking blue. The disk is active.

Solid red. The disk was removed, failed, or is resynchronizing. See the display
screen for details.

Off. No disk is present.

Disk LEDs

Two LED status indicators are built into this port, one green and one amber. They
indicate port speed and activity as follows:

Green on, amber off. 1000 Mbps connection speed, no activity.

Green blinking, amber off. 1000 Mbps connection speed, activity.

Green off, amber on. 10 Mbps or 100 Mbps connection speed, no activity.

Green off, amber blinking. 10 Mbps or 100 Mbps connection speed, activity.

Green off, amber off. No connection.

Rear panel Ethernet port
LEDs

Displays messages about the status of your storage system. Note that the status
display screen goes to sleep to prevent burn-in. To wake the status display screen,
activate the proximity sensor, press the touch pad, press the OK button, or press
the Power button once. If the storage system reports an abnormal operation or error,
the status display screen stays on.

Status display screen

This section describes how to power on and shut down your system. If you must shut down the system, use
one of the preferred shutdown methods whenever possible.

When the system is connected to a power supply and the Power switch is in the On position, the system
automatically powers on.

You can also power on the system by pressing the Power button on the front panel of the system.

You can gracefully shut down your system by using the Power button or the ReadyNAS local admin page.

For information about how to gracefully shut down your system using the ReadyNAS local admin page, see
the ReadyNAS OS 6 Software Manual, which is available at