Netgear EDA500 – ReadyNAS Expansion Chassis 5-Bay, Diskless Guia Do Programa

Use SNMP management systems such as HP OpenView or CA UniCenter for remote monitoring of the ReadyNAS.
(Management over SNMP is not supported.)

Log in to your ReadyNAS.

Select System > Settings > Services.

Click the SNMP button.

Configure the settings as explained in the following table:

Select the check box to enable SNMP globally. Clear the check box to disable SNMP globally.

Enable SNMP

Enter the community. Normally, you would enter public for a read-only community and
private for a read/write community.You can leave the Community field set to public (which
is the default setting) or you can specify a private name if you use a more segregated
monitoring scheme.

Community

Enter the IP address to which the ReadyNAS sends the traps that it generates. For information
about the types of messages that the ReadyNAS sends, see 

 on page 194.

Trap Destination

Enter a network address that specifies the hosts that are allowed to access the ReadyNAS.

Hosts Allowed Access

Click the Apply button.
Your settings are saved.