Netgear RDD1 – ReadyDATA 516 Disk Packs RDD1LT02, RDD1LT03, RDD1LT04, RDD1SM01 Manual Do Equipamento

You can obtain information about the status of your storage system by reviewing the 
indicators listed in the following table.

Disk LEDs 

A Disk LED next to each drive bay indicates the status of the disk inside. The disk 

LEDs have these states:

•

Solid blue. Power is on and a disk is present.

•

Off. No disk is present.

Rear panel Ethernet port 
LEDs

Two LED status indicators are built into this port, one green and one amber. They 
indicate port speed and activity as follows:

•

Green on, amber off. 1000 Mbps connection speed, no activity.

•

Blinking green, amber off. 1000 Mbps connection speed, activity.

•

Green off, amber on. 10 Mbps or 100 Mbps connection speed, no activity.

•

Green off, blinking amber. 10 Mbps or 100 Mbps connection speed, activity.

•

Green off, amber off. No connection.

Status display screen

Displays messages about the status of your storage system. The status display 
screen goes to sleep to prevent burn-in. If the storage system reports an abnormal 
operation or error, the status display screen stays on.

This section describes how to power on and shut down your system. If you need to shut 
down the system, use one of the preferred shutdown methods whenever possible.

When the system is connected to a power supply and the Power switch is in the On position, 
the system automatically powers on. 

You can also power on the system by pressing the Power button on the front panel of the 
system.

You can gracefully shut down your system by using the Power button or ReadyDATA 
Dashboard.

The system’s IP address is not displayed on the status display screen when 

in Tech Support mode.