Netgear RDD1 – ReadyDATA 516 Disk Packs RDD1LT02, RDD1LT03, RDD1LT04, RDD1SM01 Guia Do Programa

Configure the settings as explained in the following table:

LACP Mode

Select the LACP mode from the drop-down list:

Off. The aggregation interface does not transmit LACPDUs to other LACP 
devices or respond to LACPDUs from other LACP devices. Select this mode 
for a static LAG. This is the default setting.

Active. The aggregation interface actively transmits LACPDUs to other LACP 

devices to set up a link channel. Select this mode for a dynamic LAG with 
active LACP.

Passive. The aggregation interface responds only to LACPDUs from other 
LACP devices. Select this mode for a dynamic LAG with passive LACP.

LACP Timer

If the LACP mode is set to Active, select a value for the LACP timer from the 
drop-down list:

Short. LACPDUs are sent frequently, with a short interval between LACPDU 
transmissions. This is the default setting.

Long. LACPDUs are sent infrequently, with a long interval between LACPDU 
transmissions.

Hash Type

Select one or more check boxes to specify the hash types to be used:

Layer 2. The channel link that is established is based on the source and 
destination MAC addresses.

Layer 3. The channel link that is established is based on the source and 
destination IP addresses.

Layer 4. The channel link that is established is based on the source and 
destination port numbers.

Select the Create button.

The new bonded channel displays as an aggregation interface (aggrX, in which X is a 
number in sequential and ascending order) on the Network screen.

To configure the new aggregation interface further, click the gear icon to the right of the 
aggregation interface. 

A pop-up menu displays:

Both the ReadyDATA and the device with which the channel link is 

established must support the same mode.