Netgear DM200 – Broadband High-Speed DSL Modem Manual Do Utilizador

Click the Add button.

To make the route private, select the Private check box.

A private static route is not reported in RIP.

To prevent the route from becoming active after you click the Apply button, clear the Active check box.

In some situations, you might want to set up a static route but keep it disabled until a later time. By
default, the Active check box is selected and a route becomes active after you click the Apply button.

Enter the settings as described in the following table.

Enter the IP address for the final destination of the route.

Destination IP Address

Enter the IP subnet mask for the final destination of the route.

If the destination is a single host, enter 255.255.255.255.

IP Subnet Mask

Enter the IP address of the gateway.

The IP address of the gateway must be on the same LAN segment as the modem.

Gateway IP Address

Enter a number from 1 through 15.

This value represents the number of routers between your network and the
destination. Usually, a setting of 2 or 3 works, but if this is a direct connection, set
it to 1.

Metric

Click the Apply button.

Your settings are saved. The static route is added to the table on the Static Routes page.

You can change an existing static route.

Launch a web browser from a computer that is connected to the network.

Enter http://www.routerlogin.net.