Netgear WNCE3001 – Universal Dual Band Wireless Internet Adapter for Smart TV & Blu-ray™ Guia Da Instalação

Installation Guide

Power 

USB

Ethernet

Reset 

button

button

WPS

Port

USB power
cable

Ethernet cable

 WNCE3001

adapter

Port

 (with stand)

 

LED

Wall mount sticker

(not shown)

Wait until the LED on the

button

WPS

 

Push the WPS button on your router. When the

Connect the WNCE3001 

wireless connection has been established, the

LED changes color to indicate the quality of the 

connection—solid green, solid amber, or solid red.

Check “Adapter LED Activity” on the reverse side for

more information about what these colors mean.

to your TV, XBox, or Blu-ray

player using the Ethernet

cable (included) and one

of the power connection

options. For more information on

power-up methods, 

see “Power Connection 

Options” on the reverse side.

WNCE3001 is blinking green.

Push the WPS button on the

WNCE3001. The LED will blink

amber and green, showing that the

WPS is running.

Congratulations! Your installation is complete.

If you have a NETGEAR router, this feature is called Push ‘N’ Connect. Look for the 

 or 

 symbols on the router to make sure the

NETGEAR router supports WPS. For non-NETGEAR routers, please refer to the user manual to determine if the router supports WPS. 
Once you know whether your router supports WPS, choose the appropriate installation method below.

WPS (Wi-Fi Protected Setup) is a simple and secured way to connect a device to an existing network.

On the computer you will use to install the WNCE3001, disconnect 

                  its wireless connection to the router and/or remove the Ethernet cable

                  currently connected to the computer. You may restore the connection 

                  after the WNCE3001 installation is complete.

:  Connect the WNCE3001 to your computer, using the Ethernet

                  cable (included) and one of the power connection options.

                  For more information on power-up methods, see “Power

Wait until the LED is blinking green. Make sure the computer 

                   gets the IP address. Then, open you Internet browser and it will

                   automatically take you to the setup page. (If not, manually type

                   http://www.mywifiext.net

as the browser address.) Follow the 

                   instructions on the setup page, then return to this guide and continue

                   to Step 4.

Disconnect the Ethernet and USB cables from your computer.

Connect the WNCE3001 to your TV, Box, or Blu-ray player. 

                  If your device does not have a USB port, see “Power 

                  Connection Options” on the reverse side.

button

WPS

 

NOTE: Make sure you go through the connection settings on your TV, XBox, or Blu-ray player after the WNCE3001 is
configured and connected. If asked for the type of connection, make sure WIRED is selected.