KitchenAid 18-Inch Width Built-In Drain Pump Ficha De Dados

NOTE: Connect drain pump to your drain in accordance with all state and local codes and ordinances. It may be desirable
to insulate drain tube thoroughly up to drain inlet to minimize condensation on the drain tube. Drain pump is designed to
pump water to a maximum height of 10 feet.

1 Drain Pump
1 Drain Tube, 

5

⁄

8

" ID x 5

1

⁄

8

" (ice maker bin to pump

reservoir inlet)

1 Drain Tube, 

3

⁄

8

" ID x 10' (pump check valve to

household drain)

1 Vent Tube, 

3

⁄

8

" ID x 32" (pump reservoir vent to ice

maker cabinet back)

3 Cable Clamp (secures vent tube to back of ice maker)
3 Screw, #8 x 

1

⁄

2

" (secures clamps to back of ice maker)

2 Screw, #8-32 x 

3

⁄

8

" (secures pump to baseplate or ice

maker)

2 Small Hose Clamps, 

5

⁄

8

" (secures vent and drain tube

to pump)

1 Large Hose Clamp, 

7

⁄

8

" (secures drain tube to bin)

Please follow the steps to install the drain pump.

1. Unplug ice maker or disconnect power.

2. Remove rear cover. Carefully pull rear cover away from

drain tube.

3. Remove old drain tube and clamp attached to bin.

Discard old tube. Clamp will be reused.

© 2001
(All Rights Reserved)

Instruction Sheet 2185944 Rev. B  7/01

w

5. Install vent tube (

3

⁄

8

" ID x 32") to pump reservoir vent.

Use one (1) 

5

⁄

8

" small adjustable clamp, supplied.

NOTE: DO NOT install household drain tube at this time.

6. Remove clamp and ground screw attached to ice maker

power cord which is mounted to the unit base. Clamp
and screw will be reused.

(continued)

4. Install new drain tube (

5

⁄

8

" ID x 5

1

⁄

8

") to pump reservoir

inlet using old clamp from step 3. See Figure 1.

Drain tube (bin to pump)
(Do not kink; trim tube
length if required)