KitchenAid 36" Island-Mount Canopy Hood Utilização E Cuidado

■

1 UL listed or CSA approved, 

¹⁄₂" (12.5 mm) strain relief

■

2 UL listed wire connectors

■

Home power supply cable

■

4 Concrete anchors for 

¹⁄₄" x 4" hex head lag bolts

(for concrete installation)

■

1 Wall or roof cap

■

Metal vent system

■

Chimney Kit Part Number 8212716 (Stainless Steel), 8212717 
(White), or 8212718 (Black). See “Assistance or Service” 
section to order.

■

Charcoal Filter Kit Part Number 8285507 for non-vented 
(recirculating) installations only. See “Assistance or Service” 
section to order.

Remove parts from packages. Check that all parts were included.

■

Hood canopy assembly with ventilator and light bulbs 
installed

■

3 Filters

■

Chimney assembly

■

Ceiling template

■

Mounting template

■

Upper chimney cover

■

Lower chimney cover

■

Parts bag containing: 

■

Damper

■

4 Wood shelf bolts

■

4 Wood shelf bolt washers

■

4 Wood shelf nuts

■

4 Bolts to attach canopy to chimney

IMPORTANT: Observe all governing codes and ordinances.

Have a qualified technician install the range hood. It is the 
installer's responsibility to comply with installation clearances 
specified on the model/serial rating plate. The model/serial rating 
plate is located inside the range hood on the rear wall of the 
range hood.

Island hood location should be away from strong draft areas, 
such as windows, doors and strong heating vents.

Cabinet opening dimensions that are shown must be used. Given 
dimensions provide minimum clearance.

Grounded electrical outlet is required. See “Electrical 
Requirements” section.

It is recommended that the hood be fastened into solid wood.

The island hood is factory set for venting through the roof or wall. 
For non-vented (recirculating) installations see “Non-Vented 
(recirculating) Installation - Style 2” in the “Install Chimney 
Covers” section.

All openings in ceiling and where island hood will be installed 
must be sealed.

The installation of this range hood must conform to the 
Manufactured Home Construction Safety Standards, Title 24 
CFR, Part 328 (formerly the Federal Standard for Mobile Home 
Construction and Safety, Title 24, HUD, Part 280) or when such 
standard is not applicable, the standard for Manufactured Home 
Installation 1982 (Manufactured Home Sites, Communities and 
Setups) ANSI A225.1/NFPA 501A*, or latest edition, or with local 
codes.

For non-vented (recirculating) installations, optional Recirculating 
Chimney Kit Part Number 8212718 (Black), Kit Part Number 
8212716 (Stainless Steel) or Kit Part Number 8212717 (White) 
must be used. These kits include a new lower chimney cover 
(that replaces the lower chimney cover shipped with the island 
hood), a charcoal filter and a diverter.