KitchenAid 30-Inch Convection Combination Microwave Wall Oven, Architect® Series II Guia Da Instalação

Gather the required tools and parts before starting installation. 
Read and follow the instructions provided with any tools listed here.

■

Phillips screwdriver

■

Measuring tape

■

Drill (for wall cabinet installations)

■

1" (25 mm) drill bit (for wall cabinet installations)

■

Level

■

Flat-blade screwdriver

■

UL listed or CSA approved conduit connector

■

UL listed wire connectors

■

Warming Drawer Deflector Kit (for ovens installed above a 
warming drawer)

Order Part Number W10489566B for white 27" (68.6 cm) kit
Order Part Number W10489564B for black 27" (68.6 cm) kit
Order Part Number W10489568A for stainless steel 27" 
(68.6 cm) kit
Order Part Number W10489567B for white 30" (76.2 cm) kit
Order Part Number W10489565B for black 30" (76.2 cm) kit
Order Part Number W10489569A for stainless steel 30" 
(76.2 cm) kit

To order, see the “Assistance or Service” section of the Use 
and Care Guide.

■

Four #8–14 x 1" screws

■

Bottom vent

■

Two #8–18 x 

³⁄₈" screws - bottom vent

■

Four grommets*

Check local codes. Check existing electrical supply. See 
“Electrical Requirements.”

It is recommended that all electrical connections be made by a 
licensed, qualified electrical installer.

*Grommets are not required or included with models KEMS379B, 

KEMS309B and KEHU309B.

IMPORTANT: Observe all governing codes and ordinances. 

■

Cabinet opening dimensions that are shown must be used. 
Given dimensions provide minimum clearance with oven.

■

Recessed installation area must provide complete enclosure 
around the recessed portion of the oven. 

■

Grounded electrical supply is required. See “Electrical 
Requirements” section.

■

Electrical supply junction box should be located 3" (7.6 cm) 
maximum below the support surface when the oven is 
installed in a wall cabinet. A 1" (2.5 cm) minimum diameter 
hole should have been drilled in the left rear corner of the 
support surface to pass the appliance cable through to the 
junction box.

■

Oven support surface must be solid, level and flush with 
bottom of cabinet cutout. Floor must be able to support a 
total weight (microwave and built-in oven) of 208 lbs (95 kg) 
for 27" (68.6 cm) models or 249 lbs (113 kg) for 30" (76.2 cm) 
models.

IMPORTANT: To avoid damage to your cabinets, check with 
your builder or cabinet supplier to make sure that the 
materials used will not discolor, delaminate or sustain other 
damage. This oven has been designed in accordance with 
the requirements of UL and CSA International and complies 
with the maximum allowable wood cabinet temperatures of 
194°F (90°C).

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety 
messages.

This is the safety alert symbol.

This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”

These words mean: