KitchenAid 30'' Convection Combination Microwave Wall Oven, Pro Line® Series Guia Da Instalação

3. Push oven completely into cabinet and center oven into 

cabinet cutout.

NOTE: If you have model KEMS379B, KEMS309B or 
KEHU309B, proceed to Step 5.

4. Insert the grommet into the mounting rail hole using a flat-

blade screwdriver. Insert the screwdriver into the grommet 
and turn 

¹⁄₄ turn counterclockwise. Make sure the grommet 

stays in position.

IMPORTANT: If the grommet is not installed, the front frame 
will be damaged. 

5. Securely fasten oven to cabinet using the #8–14 x 1" screws 

provided. Insert the screws through hole in the grommet. Do 
not overtighten screws.

6. On some models, the oven vent is recessed inside the 

packaging. See the following instructions to install.

■

Insert the vent tabs (B) into slots (A) in the oven frame.

■

With one #8–18 x 

³⁄₈" screw (C) for each side of the vent, 

fasten vent securely to the oven.

7. Replace oven racks.

8. Replace oven door by inserting ends of hinges into hinge 

slots in the oven frame.

9. Push hinges in as far as they will go and open the oven door. 

You should feel the oven door drop into place.

10. Rotate both hinge latches back to the locked position.

11. Check that door is free to open and close. If it is not, repeat 

the removal and installation procedures. See “Prepare Built-In 
Microwave/Oven Combination” section.

12. Reconnect power.

13. Display panel will light briefly, and “PF” should appear in the 

display.

14. If display panel does not light, please reference the 

“Assistance or Service” section of the Use and Care Guide or 
contact the dealer from whom you purchased your oven.

On combo microwave/oven models installed above a warming 
drawer, a warming drawer deflector kit must be installed. See the 
“Tools and Parts” section for ordering information.

1. Align the deflector (B) with the vent (C) as shown.

2. Using two #8-18 x ¼" screws (A) on each side of the deflector 

(B), fasten the deflector securely to the vent.

NOTE: On 27" (68.6 cm) models, only one #8–18 x ¼" screw 
is used on each side.

3. Align vent tab (B) with oven frame (A) as shown.

³⁄₈" screw

A

B

C

A

B

D

C

¹⁄₄

B

A

C

B

A