KitchenAid 42'' Island-Mount 600 CFM Canopy Hood, Architect® Series II Utilização E Cuidado

1. Determine the required location for the home power supply 

cable and drill a ½" (1.3 cm) diameter hole for wire access.

2. Run wire through the home power supply cable according to 

the National Electrical Code or CSA Standards and local 
codes and ordinances. There must be enough ½" conduit 
and wires from the fused disconnect (or circuit breaker) box 
to make the connection in the hood’s electrical terminal box.

NOTE: Do not reconnect power until installation is complete.

3. For vented installations only: Using a jigsaw or keyhole 

saw, cut a 6½" (16.5 cm) diameter hole for the vent duct.

4. Attach the upper horizontal support bracket with 4 - 5 x 45 mm 

wood screws.

IMPORTANT: All screws must be installed into wood. If there 
is no wood to screw into, additional wall framing supports 
may be required.The ceiling support structure must be 
capable of holding 80 lbs (36.6 kg).

Assemble and Install Range Hood

1. Install transition on top of hood (if removed for shipping) with 

2 - 3.5 x 9.5 mm sheet metal screws.

2. Position the 4 vertical supports (A) with notches at the bottom 

and attach to the range hood using 16 - 4.2 x 8 mm screws. 

3. Attach the horizontal support (B) using 8 - 4.2 x 8 mm screws.

4. Attach a second set of vertical supports (A) and set the 

vertical height (B). See “Installation Dimensions” in the 
“Location Requirements” section to help determine the 
desired dimension for the vertical height “B.”

Secure with 16 - 4.2 x 8 mm T20

® 

 screws.

5. Using 2 or more people, lift the range hood assembly and 

attach it by snapping the vertical supports to the spring clips 
in the upper horizontal support bracket that is mounted to the 
ceiling.

NOTE: The range hood assembly must be held in place while 
install the screws in the next step.

6. Install 16 - 4.2 x 8 mm screws and tighten to secure.

1. Install vent system.

2. Push duct over the exhaust outlet. Seal all connections with 

vent clamps.

3. Use caulk to seal all openings.

A

B

A

B

A

A

B

A

A

A