KitchenAid 42'' Island-Mount 600 CFM Canopy Hood, Architect® Series II Guia Da Instalação

Install Duct Covers

NOTE: Remove the film from the duct covers.

1. Assemble the upper duct covers together and install the duct 

covers around the support frame. The larger hole in the 
flanges of the upper duct cover must be outside the smaller 
hole in the mating flange of the other upper duct cover.

2. Secure the upper duct covers together with two 3.5 x 6.5 mm 

screws at the top and two 2.9 x 3 mm screws at the bottom. 
Install 1 screw on each side at the top and bottom of the 
assembled duct covers.

NOTE: For non-vented (recirculating) installation, the slotted 
holes in the upper duct covers will be visible when assembled. 
For vented installations, the slotted holes will be hidden down 
inside the lower duct covers.

3. Slide the upper duct covers up the frame to the ceiling and 

secure to the upper horizontal support with 2 - 3.5 x 6.5 mm 
screws.

4. Place the long end of the plastic clips (2) into the bottom of 

the front lower duct cover.

5. Install the lower duct cover (front) to the range hood canopy. 

Spread the lower duct cover opening slightly and position it 
over the upper duct cover. Set the lower duct cover in place. 
Position so the flanges of the lower duct cover set into the 
flanges of the upper duct covers.

A

A

B

C

C

A

B

C

B

C

A

D

B

A

A

B

D

C