KitchenAid 1.4 cu. ft. Capacity Architect® Series II 900 Watts 27" Width Guia Da Instalação

Gather the required tools and parts before starting installation. 
Read and follow the instructions provided with any tools listed 
here.

■

Phillips screwdriver

■

Measuring tape

■

Level

■

Drill

■

¹⁄₈" (3.2 mm) drill bit 

■

A UL listed or CSA approved conduit connector

■

UL listed wire connectors

Check local codes. Check existing electrical supply. See 
“Electrical Requirements.”

It is recommended that all electrical connections be made by a 
licensed, qualified electrical installer.

IMPORTANT: Observe all governing codes and ordinances. 

■

Cabinet opening dimensions that are shown must be used. 
Given dimensions provide minimum clearance with 
microwave oven.

■

Recessed installation area must provide complete enclosure 
around the recessed portion of the microwave oven. 

■

Grounded electrical supply is required. See “Electrical 
Requirements” section.

■

Electrical supply junction box should be located 3" (7.6 cm) 
maximum below the support surface when the microwave 
oven is installed in a wall cabinet. A 1" (2.5 cm) minimum 
diameter hole should have been drilled in the right rear or left 
rear corner of the support surface to pass the appliance cable 
through to the junction box.

NOTE: For undercounter installations, it is recommended that 
the junction box be located in the adjacent right or left 
cabinet. If you are installing the junction box on the rear wall 
behind the microwave oven, the junction box must be 
recessed and located in the upper or lower right or left corner 
of the cabinet. Otherwise, the microwave oven will not fit into 
the cabinet opening.

■

For installation above single built-in oven the junction box 
must be located inside upper cabinet.

■

If you are installing the junction box on rear wall behind the 
microwave oven, the junction box must be recessed and 
located in the upper or lower right or left corner of the cabinet; 
otherwise, the microwave oven will not fit into the cabinet 
opening.

■

Microwave oven support surface must be solid, level and flush 
with bottom of cabinet cutout. Floor must be able to support a 
weight of 110 lbs (50.0 kg).

IMPORTANT: To avoid damage to your cabinets, check with your 
builder or cabinet supplier to make sure that the materials used 
will not discolor, delaminate or sustain other damage. This oven 
has been designed in accordance with the requirements of UL 
and CSA International and complies with the maximum allowable 
wood cabinet temperatures of 194°F (90°C).

A

B

C

D

A