KitchenAid 1.4 cu. ft. Capacity Architect® Series II 900 Watts 27" Width Guia Da Instalação

1. Using 2 or more people, lift the microwave oven partially into 

the cabinet cutout above the spacer bars. Place the 
microwave oven on top of the spacer bars and to the outside 
of the guide flanges.

NOTE: Open the microwave oven door and push against the 
seal area of the microwave oven front frame when pushing 
the microwave oven into the cabinet. Do not push against the 
outside edges.

2. Push against the front frame of the microwave oven to push 

the oven into the cabinet. Push the microwave oven 
completely into the cabinet and center in the cabinet cutout.

3. Using a 

¹⁄₈" (3.2 mm) drill bit, predrill pilot holes into the 

cabinet through the holes in the mounting rails on each side 
of the microwave oven.

4. Securely fasten microwave oven to cabinet using the 2 

screws provided. Insert the screws through holes in mounting 
rails. Do not overtighten screws.

5. Reattach the bottom vent that was removed in the “Install 

Spacer Kit” section.

6. Replace oven racks, turntable and support hub.

7. Reconnect power. 

8. Display panel will light briefly, and “PF” should appear in the 

display.

9. If display panel does not light, please reference the 

“Assistance or Service” section of the Use and Care Guide or 
contact the dealer from whom you purchased your 
microwave oven.

1. Check that all parts are now installed. If there is an extra part, 

go back through the steps to see which step was skipped.

2. Check that you have all of your tools.

3. Dispose of/recycle all packaging materials.

4. For microwave oven use and cleaning, read the Use and Care 

Guide. 

1. Turn power on.

2. When “CLOCK ENTER TIME” appears in the display, press 

START/ADD A MINUTE.

3. Fill a microwave-safe container with 1 cup (250 mL) of water 

and place container inside microwave oven on the turntable. 
Close door firmly.

4. Touch START/ADD A MINUTE twice to set cooking time to 

“2:00” minutes. Microwave should begin cooking, interior 
light should be on, and the display should count down the 
remaining time.

■

Household fuse is intact and tight; or circuit breaker has 
not tripped.

■

Electrical supply is connected;

■

See “Troubleshooting” section in the Use and Care Guide.

■

If an error code (“F” followed by a number plus “E” 
followed by a number) appears in the display, turn off the 
microwave oven and contact a qualified technician.

When the display reads “1:00” minute, open the microwave 
oven door. The microwave should stop cooking. Close door 
firmly. The interior microwave oven light should turn off.

5. Press START/ADD A MINUTE to resume preset cycle. 

Microwave should begin cooking, and the microwave oven 
interior light should be on.

Let microwave oven complete cooking time. A tone will 
sound 3 times at the end of the cooking time.

6. Open microwave oven door and slowly remove container. 

Water in container should be hot.

Please reference the “Assistance or Service” section of the 
Use and Care Guide or contact the dealer from whom you 
purchased your built-in microwave oven.

C

B

A

C