KitchenAid 30-Inch 5 Burner Gas Convection Range with Warming Drawer Guia Da Instalação

1. Remove the anti-tip bracket from where it is taped inside the 

storage drawer, warming drawer, or premium storage drawer.

2. Determine which mounting method to use: floor or wall.

If you have a stone or masonry floor, you can use the wall 
mounting method. If you are installing the range in a mobile 
home, you must secure the range to the floor.

3. Determine and mark centerline of the cutout space. The 

mounting bracket can be installed on either the left-hand side 
or right-hand side of the cutout. Position mounting bracket 
against the wall in the cutout so that the V-notch of the 
bracket is 12

⁹⁄₁₆" (31.9 cm) from centerline, as shown.

4. Drill two ¹⁄₈" (3 mm) holes that correspond to the bracket 

holes of the determined mounting method. See the following 
illustrations.

5. Using the two #12 x 1⁵⁄₈" (4.1 cm) Phillips-head screws 

provided, mount anti-tip bracket to the wall or floor.

6. Move range close enough to opening to allow for final gas 

and electrical connections. Remove shipping base, 
cardboard or hardboard from under range.

7. Move range into its final location, making sure rear leveling 

leg slides into anti-tip bracket.

8. Move range forward onto shipping base, cardboard or 

hardboard to continue installing the range using the following 
installation instructions.

1. Apply pipe-joint compound made for use with LP gas to the 

smaller thread ends of the flexible connector adapters (see B 
and G in the following illustration). 

2. Attach one adapter to the gas pressure regulator and the 

other adapter to the gas shutoff valve. Tighten both adapters, 
being certain not to move or turn the gas pressure regulator.

⁹⁄₁₆

Centerline

B

A